
Pilots the pre-flight is finally done, I had to replace the R flap servo which conveniently died shortly after I glue the fuselage together. I had to cut the top of the fusi to get access to the servo wires and now used mini rare earth mags to secure it. I was planning on this before I started and turns out I would need it sooner than I expected! Also with such limited space under the canopy I would suggest its a good mod on this plane as you can place the Rx there and dont have to worry about routing all the wires to the canopy area like I did... Because I have a 9 channel JR9503 I had to ditch the parachute, smoke bombs and ejection canopy for now because I wanted the TV on a switch, but since I ran all the wires up front I can change the set up easily-- could Y the L AIL, L ELEV, L TV and same for R side and Y the Rudder, Rudd TV and steering-- that way you save 3 channels for the chute, smoke and canopy release. In this config your TV is always on.
mig29preflight2.mov
mig-29
LX
blitzrcworks
bananahobby
HSW
Russian
Swifts
Team
Strihzi
12
channel
radio
control
plane
jr
r921
TV
thrust
vector
360
degree
remote control
jet
airplane
Стрижи.ру
CH
inthetubedeep