ZLOIND - Wireless network notifier with Arduino - Arduino + LEDs + Potentiometer + Speaker
* Perldoc description: Zloind is a script to check from the tool "iwlist", the access points detected by the system wireless interface. It captures the ESSID and the type of encryption, then it'll send via serial port an ASCII char that will be decoded by Arduino and executed by the board. During the scanning of the access points, the script prints also a notification in the shell screen. You can also enable the log capability which allow you to make a list of all AP that iwlist detects. If you want to use this script you need to install the module Device::SerialPort, which is fundamental for the correct serial communication with Arduino. * How to use it: First of all, upload the file core.pde on your Arduino board. If everything was correctly done, you'll be able to run the Perl script zloind.pl and type the name of the arduino device recognized on your system: Example: /dev/ttyACM0 Remember that you must be root to execute the Perl script. The script will ask you to enter 2 INPUT the first is the serial port where Arduino is communicating with the system, and the second one is the wireless network interface. After that, the script will start scanning the zone printing on shell screen all the access point captured.
Arduino led lights potentiometer wireless wifi notifier notify notifier wireless zloind network arduino uno uno electronics cell solder Perl gnu general public license gpl open source open hardware gnu linux linux script perl script perl arduino speaker leds wifi shield shield arduino shield computer informatics programming programming arduino lucky box craccaoscrocca cracca o scrocca robot serial port serial scan scanning technology yacumanajiri
